Cisco Router Show Commands

 The show commands are very useful Cisco IOS commands. The Cisco Router show commands can be used to examine nearly everything about a router and its configuration. Following table lists important Cisco Router Show Commands and use.
  

Command
Description
Router#show interfaces Displays statistics for all interfaces
Router#show interface e0 Displays statistics of e0 interface. You may use other interface also.
Router#show ip interface brief Displays a summary of all interfaces, including status and IP address assigned
Router#show controllers serial 0 Displays statistics for interface hardware. Statistics display if the clock rate is set and if the cable is DCE, DTE, or not attached
Router#show clock Displays the router clock.
Router#show hosts Displays local host-to-IP address addresses of hosts on the network to which you can connect
Router#show users Displays all users connected to device
Router#show history Displays history of commands used
Router#show flash Displays info about Flash memory
Router#show version Displays info about loaded software
Router#show arp Displays the ARP table
Router#show protocols Displays status of configured Layer 3 protocols
Router#show startup-config Displays configuration saved in NVRAM
Router#show running-config Displays configuration currently running in RAM

Enjoy…!

  1. No comments yet.
  1. No trackbacks yet.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: